See support and enquiry pack. Use our contact form.
Also see toolpath notes and projects.
Routine care for reliable Trophy Bench 80 cutting
Keeping your Trophy Bench 80 in top shape is straightforward but essential for smooth jobs, especially when the week gets busy with awards, plaques or signage. Wipe the lens and mirrors with proper optics wipes at the start of the day to keep the beam strong and cuts crisp. Check the chiller to ensure the laser tube runs with clean distilled water, top up if needed, and make sure the water is not cloudy. Belts must be snug but not tight, with no fraying or slack; tension them if you see uneven movement. The extraction duct should vent outside, with no kinks or blockages, as acrylic and MDF smoke builds up quickly indoors. If your cell includes a rotary or removable honeycomb bed, give these a quick brush to prevent debris buildup that can mark the underside of awards or plates. For locations with coastal humidity, check for condensation on the optics and keep material dry and flat.
- Wipe optics daily
- Use only distilled water in the chiller
- Tension belts if movement is loose
- Brush beds and rotary attachments
- Check extraction airflow
What to check if the Trophy Bench 80 is not behaving
When something is off, a few quick checks can save you time. If the laser is losing power or cutting unevenly, start by checking that the focus distance is set correctly for your lens. Dirty mirrors or a fogged lens make the beam weak, shine a torch and look for marks or cloudiness. If the cut lines look wavy or parts aren’t lining up, inspect the belt tension and look for any debris on the rails. A strong smell or more smoke than usual likely means the extraction is blocked or the filter is full. If the water in the chiller is warm, cloudy or low, this can cause tube errors or reduced performance. For rotary jobs, double-check that the rotary is plugged in fully and the material is seated squarely.
- Focus and lens height correct
- Mirrors and lens clean and clear
- Belts tensioned, rails clear
- Extraction duct not blocked
- Chiller water clean and topped up
Send us a message for help with a clear handoff
If you run into trouble, send us a message using our contact form and include as much detail as you can. Attach clear photos of your Trophy Bench 80, especially close-ups of the issue area, whether it’s the lens, a finished award, or the touchscreen. Tell us what material you’re using, the thickness, and the settings you tried (power, speed, focus). Note what changed: new material, different settings, a noisy chiller, or a recent clean. If the machine worked well just before, mention what happened between jobs. With these details, our team can get you sorted faster, whether you’re at Sunnyrock or one of the showrooms.
- Photos of the issue and machine
- Material type and thickness
- Settings used: power, speed, focus
- What has changed since it last worked
What our EngravCut Studio customers say
Verified Google reviews